It is recommended to reboot the computer after running the update if the firmware version does not change on the initial section of the Toolbox. The update should work properly at that point. You can download the firmware from this location on Kingston’s official website.Īfter the download is complete unzip the folder and run the Toolbox from that folder. If you just downloaded the Toolbox and not the firmware update the update does not work properly as the plain toolbox is not linked to the firmware file to be downloaded. The LED at the SSD becomes active for a short time at the very beginning of the power on, but after say 1. Make sure the drive is being detected in the BIOS as well, if not the BIOS may need to be updated. The problem is - the SSD does not start on power on. The SSD should be detected at that point. These drivers can be saved to a USB drive then loaded at that point of the installation. If you have access to another computer with Internet access, you can go to your computer/motherboard manufacturer's website and locate the latest SATA chipset drivers. Windows 7 does not always include the SATA drivers necessary to detect the SSD for every system. Kingston SSD - Location 0(Channel 1, Target 0, Lun 0) The Windows Device Manager reports that the Spinning Disk - Location 0(Channel 0, Target 0, Lun 0) The Spinning disk boot drive is plugged into the SATA1 port of the mother board, and the SSD is plugged into the SATA2 port. \\.\PHYISICALDRIVE1: Detected as the primary drive \\.\PHYSICALDRIVE0: Not supported - Identify unrecognized \\.\PHYSICALDRIVE1: Detected as the primary driveĭevice 0 not available with reason code 2ĭevice 1 not available with reason code 2 \\.PHYISICALDRIVE0: Detected as a secondary drive However when scanning for the drives I see this from the SSD Manager: Querying devices. The comment from reminded me that I have also tried the Kingston SSD Manager and that also does not see my SSD. But the tools still don't see the drive and I still can't update the firmware. I did steps 1 and 2 on my El Capitan system. Update the firmware using the Kingston tools. Copy the Kingston Linux image onto the SSD drive.Is there anything special I should be doing to get the software to see the drive? Without this software it seems you can't update the drives firmware.Īs per a comment below from it should also be possible to update the firmware through the USB port of an OS X system ( SV300S37A - Solid-State Drive SSDNow V300). I followed these instructions and the SSD toolbox still doesn't see my drive. Go to IDE ATA/ATAPI controllers>AMD SATAĬontroller or Intel SATA Controller. To do this, right click onĬomputer and choose manage. The Intel RST driver and revert back to the Microsoft default AHCIĭriver and then run the toolbox. If your computer has an Intel based system, you may need to disable It states "No SandForce drives found" or "No Kingston drives found". I also discovered on the Kingston support site this: Windows 7 Home Premium SP1 (on a Lenovo CIH61M v1.0 MB from 2011'ish) sees it and I can copy files to/from it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |